You are here

Course Details

Course Name
Pipeline - "Bending Driver" - Sideboom
This session is not currently accepting new enrollments.
Please check back later or contact your local training center for additional information.
6 days
Crosby, TX

This is a one week course, the class will run 6 consecutive days, Monday - Saturday, 10 hours a day. This class is intended for an operator who has had some experience working on the ROW utilizing a sideboom. Previous attendance in the 3 week pipeline sideboom course is recommended but not reqiured. 

Subjects to be covered are as follows: 

1. Recognize the proper skid sets to set pipe on. 

2. How to properly roll a joint of pipe

3. How to properly feed the pipe into the bending machine

4. Recognize hazard/pinch point areas

5. How to properly lay out/set up pipe joints on the ROW after the joints have been bent

6. How to properly tow the bending machine

7. Be able to recognize a good spot to set up the bending machine on the ROW

8. How to properly lift a joint of pipe while it is in the bending machine

9. How to properly remove a joint of pipe from the bending machine after it is bent. 

10. Safety and vocabulary of the bending/set up operations 

This is a one week course, the class will run 6 consecutive days, Monday - Saturday, 10 hours a day. This class is intended for an operator who has had some experience working on the ROW utilizing a sideboom. Previous attendance in the 3 week pipeline sideboom course is recommended but not reqiured. 

Subjects to be covered are as follows: 

1. Recognize the proper skid sets to set pipe on. 

2. How to properly roll a joint of pipe

3. How to properly feed the pipe into the bending machine

4. Recognize hazard/pinch point areas

5. How to properly lay out/set up pipe joints on the ROW after the joints have been bent

6. How to properly tow the bending machine

7. Be able to recognize a good spot to set up the bending machine on the ROW

8. How to properly lift a joint of pipe while it is in the bending machine

9. How to properly remove a joint of pipe from the bending machine after it is bent. 

10. Safety and vocabulary of the bending/set up operations 

2 / 4
Pipeline (PLCA)
No
No